Hi Florian,
thanks for the response.
I tried to change the mode to ...
https://fl0rian.wordpress.com/2016/05/29/beosound-9000-ir-receiver-repair/#comment-41264
In reply to Rainer. Hi, you need to make sure to change to a mode other than 0 after repair ...
https://fl0rian.wordpress.com/2016/05/29/beosound-9000-ir-receiver-repair/#comment-41263
Hi,
i am about to do the same, as my MK1 does not respond either. So just to clarify: Do I have to go into service mode...
https://fl0rian.wordpress.com/2016/05/29/beosound-9000-ir-receiver-repair/#comment-41262
فرق کابل dvi با vga Beosound 9000 – IR receiver repair | Handhelds, Linux and Heroes
https://fl0rian.wordpress.com/2016/05/29/beosound-9000-ir-receiver-repair/#comment-40643
In reply to Staffan. Thank you Staffan for the helpful information. Do you remember the impo...
https://fl0rian.wordpress.com/2016/05/29/beosound-9000-ir-receiver-repair/#comment-40162
In reply to Florian. Hi again, yes, you were totally right Florian; the MK1 and MK3 are very...
https://fl0rian.wordpress.com/2016/05/29/beosound-9000-ir-receiver-repair/#comment-39882
In reply to Florian. Thanks Florian, well the MK3 manual can be found everywhere but there a...
https://fl0rian.wordpress.com/2016/05/29/beosound-9000-ir-receiver-repair/#comment-39881
Hi, I do not remember offhand all the steps in detail but I remember it was not really obvious. If I remember correctly there is some cable to unplug or similar and some screws on the back side h...
https://fl0rian.wordpress.com/2016/05/29/beosound-9000-ir-receiver-repair/#comment-39880
Hi Florian, any idea how to get the aluminium front cover/plate of my BS9000 MK 1? I cannot swing it around or even lift it so much to remove the IR receiver. Seems stuck along the outer edge. An...
https://fl0rian.wordpress.com/2016/05/29/beosound-9000-ir-receiver-repair/#comment-39879
Hi. I have bought an NCDR 2011 and Cid display for my 2001 omega 2,6v6 elegance I had to add a few ekstra cables for the display, and I'm pretty sure the cables are correct now. The display works...
https://fl0rian.wordpress.com/2013/04/10/fixing-the-ncdc-2015-0khz-failure/#comment-39563