We happen to have a Yanmar 4JH3 engine in out 43DS, but I suspect this is a fairly generic question. I'd like to find +12V within the engine...
https://www.cruisersforum.com/forums/f54/finding-engine-live-dc-power-285628.html
Hey All! I've been sailing about 20 years. Done a bit of teaching, a little racing, but mostly just cruising the San Juans and Puget Sound. ...
https://www.cruisersforum.com/forums/f9/hello-from-the-san-juans-285626.html
Hello, I have a 48V 50Ah LifPo Battery I use for the electric motor of my dinghy. Right now I charge this over the inverter with a 48V charger. Not...
https://www.cruisersforum.com/forums/f14/integrating-48v-lithium-in-12v-system-285625.html
Hi everyone, I have a spectra Catalina 300 with Mpc5000, but after spending several hours on the phone with spectra techs and @Tellie, we've come...
https://www.cruisersforum.com/forums/f115/flow-and-tds-meters-for-watermaker-285623.html
Hello fellow sailors My windlass stoped working The motor runs well on both directions but the shaft does not turn. I’ve decided to dismount it...
https://www.cruisersforum.com/forums/f55/how-to-drop-a-maxwell-windlass-3500-a-285622.html
I have done in my computers not to start the screensaver while ocpn is active, but I cannot find anywhere in the program in my new installation (W11...
https://www.cruisersforum.com/forums/f134/lost-with-screensaver-285619.html
Hey guys anyone sailed in to the Solomon Islands with a dog and how hard was the process of import your dog
https://www.cruisersforum.com/forums/f92/sailing-dogs-into-solomon-islands-285618.html
Would appreciate identification & suggested replacements for the circa 2009(?) Airmar transducers shown in the attached photos. Ideally I would...
https://www.cruisersforum.com/forums/f13/drop-in-replacements-for-airmar-transducers-285617.html
I am looking to undertake an RYA OYM course in South Africa; this is mainly because I have the benefit of cheap flights to S.A which, coupled with...
https://www.cruisersforum.com/forums/f112/rya-offshore-yachtmaster-course-285616.html
I have set up my old 1986 boat to be a smart boat! Here's what I've been able to achieve for less than $400 using free open-source software and...
https://www.cruisersforum.com/forums/f13/smart-boating-using-free-software-285615.html
We have a 2010 Beneteau 40 located on the hard near Baltimore. It has a cast iron keel with some rust spots showing. I'll sand the rusted areas...
https://www.cruisersforum.com/forums/f55/rust-prevention-coating-for-iron-keel-285614.html
The tool bar that shows chart scale, zoom in , zoom out, ect (see attached screen shot) is square in the middle of the chart... Where my boat is lol....
https://www.cruisersforum.com/forums/f134/move-chart-options-bar-285613.html
Hi all, I’m installing a Beta Marine 50 engine in my 1983 Pearson 424 and need to raise up the aft part of the fiberglass “pan” that my aft engine...
https://www.cruisersforum.com/forums/f54/3-4-star-board-under-motor-mounts-285610.html
I have a Raymarine Quantum 2 Doppler, and it does not reliably see small fishing boats in coastal situations, regardless of tuning. Open boats...
https://www.cruisersforum.com/forums/f13/does-your-radar-see-small-fishing-boats-285609.html
As an American living in France, I have been going through the usual motions to avoid paying the VAT, but with my US based boat insurance coming up...
https://www.cruisersforum.com/forums/f2/french-boat-insurance-285608.html