I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.
Hi All..... I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill. Has anyone adapted the Kreg guide to work with...
I have a k5 jig. Had an issue and took it apart. Now the small ball that is inside the ratchet compartment is gone. Anyone know the size needed to replace it?
Good morning! Thank you for your involvement in the Kreg Owners’ Community. In an effort to consolidate the various online communities we manage, this Ning forum will be archived on July 18th. ...
I have not been too active recently, but I am sad to see this community being ended and archived. Have gotten a lot of useful info from the forum over the years. Facebook is not somewhere I w...
I recently added the Kreg XL jig to my collection of awesome Kreg tools. My question: When joining a a 2x4 to a 4x4 using 4” XL screws, I should attached the jig to the 2x4 and set it to the 2x...
This might have been discussed before but I can't find the right answer. I recently upgraded to a Kreg 720 Pro and gave away my old R3. The old kit had a chart in inches & mm for setting the co...
Hi everyone, Just got my 720 jig. I noticed that when I put the drill bit into the drill guide, it does not go through. The tip of the drill bit does not extrude from the guide. A photo is atta...
Hi everyone, I seem to remember a spreadsheet a while ago to help calculate where to position the mini jig, does anyone still have it or is there a better way to do things now? hope you can hel...
Help!!! from anyone UK or Ireland side , I have purchased the Kreg router table with the Kreg Precision Router Lift, my problem is that I cannot find a router to fit with the correct motor dia...